YOUR ORDER SHIPS THE SAME DAY
On in-stock orders placed
before 4pm Eastern Time.

VIEW CART

1-866-895-9295 Mon-Fri 7am to 1am ET Sat-Sun 7am to 11pm ET

How to replace a dishwasher's bi-metal switch:



Image not currently available Replacing a bi-metal switch

Note:
Disconnect the power source to your dishwasher before you conduct this or any other repair. Either unplug the unit from the wall outlet, remove the appropriate fuse from the fuse box, or flip the appropriate breaker in the circuit breaker panel.

Before you can begin to replace your dishwasher's bi-metal switch, you must first locate the device. It is located within the door assembly, in very close proximity to the detergent dispenser cup. You will need to gain access to the inside of the door.

Examine the outside of the appliance. Depending on the model, you will have to remove either the entire internal door panel, or the entire external door panel. In each case, the panel can be removed by removing anywhere from 6 - 10 screws. Be careful to not remove the screws at the very bottom of the door that are actually a part of the hinge assembly. Removing the hinge assembly screws will remove the entire door from the appliance, which is not at all necessary to replace the unit's bi-metal switch. With all of the screws removed, the door panel should be easy to lift off of the door assembly. If you have difficulty lifting the panel, look for additional screws you may have missed.

With the door panel removed, locate your dishwasher's detergent dispenser cup and the bi-metal switch assembly. Before you begin to test the switch, you should first check its alignment. If the detergent cup door is open, shut it. Use a small screwdriver to gently push in on the metal until the door of the detergent cup opens. It might just be that the switch has fallen out of alignment. Sometimes, only a slight adjustment is needed to allow the switch to open the detergent cup door. If this is not the case with your dishwasher, continue with the replacement.

There are two wires connected to the bi-metal switch. Label them so that you will be able to correctly reconnect them later. Remove each of the two wires from their respective terminals - they are connected with slip-on connectors. When removing the wires, grasp the connectors and pull firmly. Do not pull on the wires themselves. You may want to use a pair of needle-nosed pliers to help you. Now you can remove the screws that hold the switch to the detergent dispenser cup.

Discard the used switch and connect the wires to the terminals of the new bi-metal switch. Reattach the new switch to the detergent dispenser using the screws from the old switch. Replace the door panel and restore power to your dishwasher.