YOUR ORDER SHIPS THE SAME DAYOn in-stock orders placedbefore 4pm Eastern Time.
Search by part or model number
Every model has its own, specific solutions. If you go to a car mechanic they'll need to know the exact make and model of your car to find the right repair parts. Appliances are the same.
See this guide for help.
Don't let a broken Hotpoint Appliance ruin your day. Repair your Appliance with parts from EasyApplianceParts.com. We offer low prices, award winning service and same day shipping on all Hotpoint Appliance parts to help you repair any of your home appliances.
Easy Part #:
In Stock - Ships Today
This kit contains one wheel and one axle. It is designed for the rear lower dishrack.
Sold individually. Order quantity needed.
This cover has the drawer slides built into it.
This part attaches to the rails, for the upper rack, to prevent the dishrack from sliding all the way out.
Sold individually. There are 2 per dryer. They attach to the outer-most sides of the bearing. Manufacture recommends to replace both slides at the same time.
There are 2 per dryer. They attach to the outer-most sides of the bearing. Manufacture recommends to replace both slides at the same time. Sold individually.
Replacement icemaker kit - electronic. This kit includes a 4 pin round plug-in connector, 6 post plug-in connector, tube and fill cup.
Be very careful when handling this igniter as it is very fragile. This igniter has a range of 2.5 to 3.0 amps. Please note - this will not replace the flat style igniters. Also known as bake and broil igniter.
Also known as Thermistor. This part is used to sense the temperature in the cabinet.
This wheel is located on the front lower rack. It includes the axle. Sold individually.
This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.
This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.
This end cap can be used for the right or left side of the refrigerator door shelf or the freezer door shelf.
This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Helps keep your dryer running as smoothly as possible with as little noise as possible.
The main tub seal is located between the transmission and the outer tub. It's the primary water seal in the outer tub for the transmission-shaft. This seal is difficult to replace and should probably be installed by a qualified technician.
This closed, hinged style bake element with screw in terminals is 15-1/4" long and 18-1/4" wide. The depth of the terminals is 2-1/2".
When looking inside the fridge, this white drawer slide rail is located on the left side of the refrigerator. Rail ONLY.
End caps sold separately.
The infinite switch controls the stove top surface burner. This switch will work with most of the electrical range models with coil burner elements.
Comes with both cam risers. This hinge kit is suitable for the bottom of either the freezer door or the refrigerator door of some refrigerators.
This part mounts in the ice dispenser.
**** The crank no longer comes with this part. You can use original crank. The crank is sold separately depending on model number of appliance.
This end cap is sold individually. It can be used for the right or left side of either the freezer or refrigerator door shelves.
The flat style gas oven igniter included in this kit has a body length of 3-3/4". This kit comes with a mounting bracket and a wire connector with a plug. *Please note: the connector plug might need to be removed and spliced to range wiring using porcelain wire nuts. This part is used to heat your oven.
This part comes with 3 round pin connection terminals.
This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan.
When activated, the auger rotates and pushes ice out of the bin through the chute to the user.
Appliance would take 4 straps. It is recommended to replace all 4 at the same time. They keep the tub in the center of the cabinet. Sold individually.
This partially open-style bake element comes with push-on terminals and is located on the bottom of the oven.
This defrost timer will cycle for twenty-five minutes after every six hours of run time. The timer itself is made of plastic, and its terminals are bent, the leads are internal, and the label is orange.
This part helps stop your dishwasher from leaking. This kit includes the impeller, seal, blade, filter, skidder and skidder holder.
This board controls the operation of the unit. Note: This part has been updated by the manufacturer. It may differ in appearance but will function the same as the original.