On in-stock orders placed
before 4pm Eastern Time.


1-866-895-9295 Mon-Fri 7am to 1am ET Sat-Sun 7am to 11pm ET

Detailed View

6447706-1-S-GE-WE1M1067-Drum Bearing Slide
6447706-1-S-GE-WE1M1067-Drum Bearing Slide 6447706-2-S-GE-WE1M1067-Drum Bearing Slide

Drum Bearing Slide

EAP Number: EAP6447706
Manufacturer: GE
Part Number: WE1M1067

This GE drum bearing slide is sold individually. They attach to the outer-most sides of the dryers drum bearing. Manufacture recommends replacing both slides at the same time. These drum bearing slides are approximately 3 inches long.

EAP #:


Compare At:


You save:


Your Price


Expert Repair Guide

  1. To replace the drum bearing slide, first make sure to disconnect power from the dryer
  2. Remove the screws holding the back cover from the control panel
  3. Then remove the top panel, to access the screws on top of the control panel
  4. Once those are removed, lift off the control panel and set it on top of the dryer.
  5. Then disconnect the two wiring harnesses from the door
  6. Next, remove the screws on the front panel so you can pull it forward and off the front of the dryer
  7. You may need to support the drum to loosen the front panel
  8. Once it’s been removed, you’ll have access to the drum bearing slides; these are located around the edge of the drum and can be removed by gently prying them off with a screwdriver.
  9. Once you’ve remove the old slides, just push the new slides in place
  10. Installation is simply the reverse of removal.