Roper Cooktop Parts

Drip Bowl - 6 Inch

17 Reviews

Part Number: WPW10196406

This six-inch chrome drip bowl is compatible with electric ranges that utilize plug-in surface burners. This bowl measures approximately 7 2/3-inch in diameter. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.

Surface Burner Plug-In Block Kit

4 Reviews

Part Number: 330031

This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.

Drip Bowl - 8 Inch

Part Number: W10196405RW

This eight-inch chrome drip bowl is intended for use with rolled terminal style plug-in surface element units. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.

Heating Element

6 Reviews

Part Number: WP4391960

The drum glide helps the front drum rotate smoothly and quietly while operating. If your dryer won’t tumble or is noisy, the glide could be worn down, causing a metal on metal noise. In this case it will need to be replaced. It is recommended to replace both glides at the same time and two is required for the dryer. The drum glide is a genuine OEM part and is sold individually. Please remember to disconnect the power to the dryer before starting your repair.

Burner Surface Element - 8 Inch

Part Number: WP3177565

The 8” burner element is a genuine OEM part that supplies heat to the cooking area on your range. It has five turns, a black/red center medallion, power burner, and looped terminal ends. If your element is not heating, you may need to replace it. The manufacturer suggests replacing the receptacle at the same time you replace the burner element. Please be sure to disconnect the power to your range before starting your repair.

Igniter Switch

Part Number: WP4330739

The igniter switch is used on a gas range/oven. When the gas burner valve knob is depressed and turned, the switch creates a spark that lights the gas and starts the burner. If the burner will not ignite you may need to replace your switch. Please remember to disconnect power to your range before starting your repair. The igniter switch is sold individually.