YOUR ORDER SHIPS THE SAME DAYOn in-stock orders placedbefore 4pm Eastern Time.
Search by part or model number
Every model has its own, specific solutions. If you go to a car mechanic they'll need to know the exact make and model of your car to find the right repair parts. Appliances are the same.
See this guide for help.
Don't let a broken Roper Range ruin your day. Repair your Range with parts from EasyApplianceParts.com. We offer low prices, award winning service and same day shipping on all Roper Range parts to help you repair any of your home appliances.
This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw.
Easy Part #:
In Stock - Ships Today
This screw is sold individually.
This part has been substituted by the manufacturer and has a hole in the center. It no longer has a solid bottom.
This closed hinged style bake element is 15-3/4 inches long and 16-5/8 inches wide. The terminal depth is three inches and they are 1-3/4 inches apart.
This part has been substituted by the manufacturer and has a hole in the center. It no longer has a solid bottom. Sold individually.
NOTE: The manufacturer recommends that you replace the burner receptacle at the same time.
This bake element is found on the bottom of the oven.
This push-to-start Robertshaw style replacement for load rated switches has a clockwise rotation. It also has a break off shaft, and comes with plastic adapters.
This white oven door trim set contains three pieces: two for the sides of the door and one for the bottom. The screws are sold separately.
10-32 hex - Sold Individually - Appliance originally takes 3 of this item.
The top of this part is now black.
This broil element is found on the roof of the oven and has push-on terminals.
The manufacturer suggests replacing the receptacle at the same time.
This round style carborundum gas oven igniter has an amperage range between 2.5 and 3.0 amps. Be very careful when handling this igniter as it is very fragile. Please note - this will not replace the flat style igniters.
Also known as bake and broil igniter.
This surface burner receptacle assembly comes with the receptacle, two wires, two wire nuts, and two pieces of heat-shrink tubing.
This kit includes the 2 side pieces and 1 bottom piece. NOTE: This kit has been updated by the manufacturer. The lower screws are no longer needed for the side trim now locks in to the lower trim piece.
This switch controls the stove top surface burner.
This kit is simple on/off mechanism that prohibits the machine from operating when the door is open.
This temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.
This plug-in surface burner element has looped terminal ends.
This control switch controls the stove top 8" surface burner.
This part is located on the inside of the oven on the top.
7-18 x 3/4" - sold individually.
This temperature sensor detects the temperature within the oven cavity.
This handle does not come with the mounting screws. They are required for installation.
NOTE: This handle has been updated and requires new mounting screws. The old handle was threaded and the new design is not. Mounting screw that is needed see related parts.
This adjustable front leveling foot is sold individually.
This kit contains one clip, a screw, and a nut.
This metallic screw is less than an inch long and comes with a plastic washer.
Part may differ in appearance, but functions same as original.