Roper Stove Parts

Light Bulb - 40W

11 Reviews

Part Number: 8009

This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.

Idler Pulley Assembly

1 Review

Part Number: WP691366

The idler pulley wheel provides the tension for a multi-ribbed belt and helps the belt to rotate the drum. The drum will not spin if the idler pulley fails to put the correct amount of tension on the belt. The wheel is white in color and is made of plastic. If the drum will not tumble, is noisy, or will not start, you may need to replace this part. This idler pulley is a genuine OEM part. Please remember to disconnect the power to your dryer before you start your repair.

Heating Element Connection Wire Kit

1 Review

Part Number: 279457

This kit is used for electric clothes dryers, and it comes with a yellow wire nut.

Round Carborundum Oven Igniter

1 Review

Part Number: 4342528

This round style carborundum gas oven igniter has 10 inch lead and amperage range between 2.5 and 3.0 amps. Be very careful when handling this igniter as it is very fragile. Please note - The bracket and screws are not included. This part will not replace the flat style igniters. Also known as bake and broil igniter.

Heating Element

6 Reviews

Part Number: WP4391960

The drum glide helps the front drum rotate smoothly and quietly while operating. If your dryer won’t tumble or is noisy, the glide could be worn down, causing a metal on metal noise. In this case it will need to be replaced. It is recommended to replace both glides at the same time and two is required for the dryer. The drum glide is a genuine OEM part and is sold individually. Please remember to disconnect the power to the dryer before starting your repair.

Surface Burner Knob

1 Review

Part Number: WP330190

The surface burner knob is black and chrome in color with a red indicator line, and measures approximately 1 1/2” in diameter. The burner knob allows you to adjust and control the heat settings on your cooktop element. If your element is not heating properly, you may need to replace the knob. The knob is made of plastic and is sold individually. This is a genuine OEM part. Please note: As per the manufacturer, with the red mark at the 12 o'clock position the flat side of the D-shaft will be at the 3 o'clock position.

Broil Element - 240V

2 Reviews

Part Number: WP660579

If your broil element is no longer heating or it has shorted out, you may need to replace it. You can use a multimeter to test the broil element for continuity. The three loop broil element is located on the roof of the oven cavity to supply heat for broiling. The element has push-on terminals and measures 12-inch wide and 19-inch long. This is a genuine OEM part. Please remember to disconnect the power to the oven before starting your repair.

Blower Wheel Clamp

Part Number: WP312967

The blower wheel clamp is used to hold the blower wheel to the motor shaft. The clamp is less than an inch long and is used with your dryer. If your blower wheel is loose or making a noise while operating, you may need to replace the clamp. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.

Lid Switch

1 Review

Part Number: W10820036

The door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open. The dryer cannot operate until the door switch signals that the door is closed. If your dryer will not start or the switch shorted out, your washer will not operate and the switch will need to be replaced. This switch is a genuine OEM part. Please remember to disconnect power to the dryer before starting the repair.

Surface Element Switch

Part Number: W10900107