Hotpoint Dryer Parts

Drum Bearing Slide - White (Sold individually)

4 Reviews

Part Number: WE1M504

This single white drum bearing slide attaches to the outer-most sides of the bearing to help support the front of the drum as it rotates. If your dryer is making loud noises or the drum will not tumble, you many need to replace the slides. The manufacturer recommends replacing both slides at the same time; there are 2 slides per dryer. This is a genuine OEM part. Please make sure to disconnect power to the dryer before starting your repair.

Drive Belt

13 Reviews

Part Number: WE03X29897

This dryer drum drive belt is 89.5" long and has four ribs. This part helps spin the drum during the drying cycle.

Drum Bearing Slide - Green (Sold individually)

1 Review

Part Number: WE1M1067

This single green drum bearing slide attaches to the outer-most sides of the bearing to help support the front of the drum as it rotates. If your dryer is making loud noises or the drum won?t tumble you many need to replace the slides. The manufacturer recommends replacing both slides at the same time. There are 2 slides per dryer. This is a genuine OEM part. Please make sure to disconnect the power to the dryer before starting your repair.

Lint Filter

11 Reviews

Part Number: WE03X23881

This is a genuine OEM part that works for some models of GE, and Hotpoint models. This Lint Filter is used for Dryer.

Front Drum Bearing

10 Reviews

Part Number: WE3M26

The drum support bearing helps your dryer operate as quietly as possible by allowing the front of the drum to glide smoothly on the felt seal of the front panel when the drum is rotating. If your dryer is noisy or making a squeaking sound, the slides are probably worn and both slides will need to be replaced. This part measures 10-inches in height and 19 1/2-inches inside width. Four drum glides are used with the drum support bearing and are sold separately. The support bearing is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.

Timer Knob

13 Reviews

Part Number: WE1M652

This timer knob for a dryer is an authentic replacement part and accepts a D-shaped shaft. The knob is white in color and measures 3 inches in diameter. The timer knob attaches onto the shaft of the timer and allows you to select the amount of time your dryer will run. If your dryer timer will not advance or your dryer will not start you may need to replace the timer knob.

Drum Glide Bearing - White (Sold individually)

Part Number: WE3M51

Duct Felt Seal

Part Number: WE09X27634

The duct felt seal allows the front of the drum to glide smoothly on the exterior panel while the drum is rotating. The seal is located between the back of the drum and the rear dryer panel. If the heat is escaping from the drum area causing the dryer to run too long or if there are marks on your clothes you many need to replace the duct felt seal. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Selector Knob with Clip

1 Review

Part Number: WH1X2721

This knob accepts a D-shaped shaft. Sold individually.

Rear Drum Bearing Kit

2 Reviews

Part Number: WE25M40

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Over time the drum bearing will wear out, once it has the dryer may make some noise and the drum bearing will need to be replaced. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.