Admiral Dryer Thermostats

Dryer Thermal Fuse

9 Reviews

Part Number: WP3392519

This thermal fuse is used in dryers as a safety mechanism that stops the flow of electricity to the motor circuit when a dryer overheats. This replacement part features two 3/16 inch terminals, and is sold individually. When this fuse is faulty, your dryer will not start or it will not heat properly. This is a one-time fuse, meaning it cannot be re-set. It must be replaced when there is no longer continuity between the terminals. It attaches to the blower wheel housing. Blown fuses can be caused by clogged dryer vents. We recommend checking to make sure all of the vents are clear when you perform this repair.

Dryer Cycling Thermostat

3 Reviews

Part Number: WP3387134

The cycling thermostat with an internal bias heater will continually cycle the heating element off and on to maintain a constant inner temperature in the dryer. This cycling thermostat has a limit of 155 degrees Fahrenheit and a differential of 25 degrees. Meaning that the heating element will cut out at 155 degrees and cycle back on once the internal temperature drops by 25 degrees. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting the repair.

Thermal Cut-Off Kit

14 Reviews

Part Number: 279816

This thermal cut-off kit for a dryer includes one high limit thermostat with a limit of 250 degrees Fahrenheit, and one thermal cut-off fuse (309 degrees). The thermal cut-off (fuse) is meant to trip at a higher temperature than that of a high limit thermostat. This is a one-time use fuse, so when it does trip, you must replace it. The hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element. This genuine OEM kit also includes flat heaters with jumper wires. Make sure to disconnect the power source to the dryer before beginning this repair.

Dryer High Limit Thermostat

3 Reviews

Part Number: WP3977767

The three-terminal high-limit thermostat with a terminal extension arm acts as a safety mechanism that keeps the dryer from overheating. When the dryer temperature reaches 221 degrees Fahrenheit, the thermostat will shut off power to the heating element until it drops by 80 degrees Fahrenheit. If your dryer has no heat, takes too long to dry or the thermostat has shorted out, you will need to replace the thermostat. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

High Limit Kit

1 Review

Part Number: LA-1053

This kit comes with three separate thermal fuses and is usually used with clothes dryers that have a fan mounted on the motor shaft. Included within this kit is the high limit (Limit: 258), the gas high limit (Limit: 240), and the gas and electric high limit thermostat (Limit: 300).

Heating Element Kit - 240V 4750W

2 Reviews

Part Number: LA-1044

This heating element assembly includes the high limit thermostat (L240-80F). The 240-volt 4750-watt, heating element produces heat for drying clothes inside your dryer. If your dryer takes too long to dry or has no heat, you should check for a blown thermal cut out or a thermal fuse. Some heating elements will often have a break in the coil element and will need to be replaced. The element measures approximately 10” L x 3.5” W and the thermostat measures 2” L x 1 1/2” W. Please remember to disconnect the power to the dryer before starting the repair. This is a genuine OEM part.

Limit Thermostat

1 Review

Part Number: WPW10116735

This hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 225 degrees Fahrenheit. The element will kick back in when the temperature drops to 185 degrees Fahrenheit - the differential of 40 degrees.

Cycling Thermostat

Part Number: WP31001192

L146-25F 240 Volt internal heater. This thermostat helps to regulate the dryer's internal temperature.

Cycling Thermostat

Part Number: WP37001136

Cycling thermostats continually cycle the heating element off and on to maintain a constant inner temperature.

Thermostat

Part Number: WP53-1096