Most Popular Parts
These are the most commonly purchased repair parts for 1101820296.
-
(9)
The water fill valve kit attaches the water lines on the back of your washer. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. This kit includes a blue body fill valve, a mounting bracket and a screw. The valve body of this part could be blue or green in color. There are two ports for water to enter, and this valve is compatible with a half inch ID hose. It has two 3/4-11x1/2 NHT hose threads. This is a genuine OEM part. Please remember to disconnect the power and the water supply before starting your repair.
-
(9)
The newer version of the coupler kit is made with new metal sleeves for added strength. This part is located between the motor and transmission on the direct drive washer that does not have a belt. The coupler will break to protect the motor from damage if the drive motor system seizes up. If your washer will not fill, will not agitate or spin, but it will drain the water from the tub, you may need to replace this part because it has failed. This is a genuine OEM part. Disconnect the power to your washer before starting the repair.
-
(9)
The clutch assembly is used on direct drive washing machines and helps spin the basket during the spin cycle to remove water from the tub. If your clutch is worn out it can cause the washer to be noisy or leave water in the tub because it won’t drain properly, which will leave your clothes soaked. The clutch assembly includes a brake cam driver, retaining ring, bearing, and a spring, depending on your model number. This is a genuine OEM part. Please remember to disconnect the power and the water supply to the washer before starting your repair.
-
(1)
This is a genuine OEM part. The push-to-start switch is composed of metal and plastic components. Compatible with dryers, the Whirlpool switch powers the appliance after the button is pressed. With a screwdriver, this item is fitted between the bracket and console. The push-to-start switch is sold individually.
-
(1)
This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.
-
(1)
Specifications: Length 79-1/8 inch, width 1/4 inch, 4 ribs, Flat.