Most Popular Parts
These are the most commonly purchased repair parts for 2176^0A.
-
(17)
This six-inch chrome drip bowl is compatible with electric ranges that utilize plug-in surface burners. This bowl measures approximately 7 2/3-inch in diameter. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.
-
(4)
This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
This eight-inch chrome drip bowl is intended for use with rolled terminal style plug-in surface element units. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.
-
The 8” burner element is a genuine OEM part that supplies heat to the cooking area on your range. It has five turns, a black/red center medallion, power burner, and looped terminal ends. If your element is not heating, you may need to replace it. The manufacturer suggests replacing the receptacle at the same time you replace the burner element. Please be sure to disconnect the power to your range before starting your repair.
-
(1)
This surface burner heating element with reinforced delta frame is six inches in diameter, has four turns and looped terminal ends. It carries 1250 watts, 240 volts and the center medallion is black in color. This element provides heat to the cooking surface on your range. If your element is not heating, shorted out around the coil, or the terminal block shorted out and damaged the ends on the element, you may need to replace this part. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. The element is a genuine OEM part and is sold individually.