Most Popular Parts
These are the most commonly purchased repair parts for AAV7000AJW.
-
This screw is sold individually.
-
(5)
This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time. NOTE: This is a redesigned part. The pump now mounts on to the base of the washer - no mounting plate needed.
-
This screw is sold individually.
-
This transmission lip seal repair kit comes in two pieces: a red four inch long piece, and a black one inch long piece. Both pieces are made entirely of plastic. This repair kit comes with and instructions sheet and it is used for some washing machines.
-
The transmission pulley and bearing kit, also known as a thrust bearing kit, is located on the drive shaft. If your washer won’t agitate during use, drum won’t drain, or there is a loud noise during operation, you may need to replace this part. A worn bearing also causes slow spinning or no spin at all. This kit includes the pulley that rotates to spin the tub, washer, and thrust bearing that fits between the pulley and the transmission shaft, 2 upper race washers, 1 lower race washer and the instruction sheet. This is a genuine OEM kit; the parts are not available separately. Please remember to disconnect the power and water supply to the washer before starting the repair.
-
(1)
The tub-to-pump hose is a flexible drain hose that connects the outer tub to the pump to carry the water from the tub to the drain pump. This hose is black in color, is made of plastic and measures approximately 17” long with a 1 1/2” diameter. If the hose becomes clogged, broken, or cracked, it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power and water supply before you start this repair.