Admiral Dryer ADE20L4W Sections

There are 4 diagrams for ADE20L4W. Click on the diagram where you think your part is located.

CONTROL PANEL (REV. A - D)

CYLINDER & DRIVE (REV. A - D)

EXTERIOR (REV. A - D)

HEATER (REV. A - D)

Most Popular Parts

These are the most commonly purchased repair parts for ADE20L4W.

Multi Rib Belt - 92-1/4"

$16.00

In Stock

(41)

This dryer drum belt has four ridges, three grooves, 1/4-inch wide and 92 1/4-inch long. The belt helps rotate the drum. If the drum does not rotate and you can still hear the motor running, the belt may have broken and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
Screw, 8/18 x 3/8

$7.40

In Stock

This screw is sold individually.
Door Catch Kit

$27.00

In Stock

The door catch helps keep the door closed while the machine is running. If your dryer will not start or the door will not close you may need to replace the door catch. This is a genuine OEM part and includes both the male (strike) and female (catch) pieces. Please remember to disconnect the power to your dryer before you start the repair.
Lint Duct Housing

$95.76

In Stock

(1)

Does not include the seal
Heating Element Kit - 240V 4750W

$60.87

In Stock

(2)

This heating element assembly includes the high limit thermostat (L240-80F). The 240-volt 4750-watt, heating element produces heat for drying clothes inside your dryer. If your dryer takes too long to dry or has no heat, you should check for a blown thermal cut out or a thermal fuse. Some heating elements will often have a break in the coil element and will need to be replaced. The element measures approximately 10” L x 3.5” W and the thermostat measures 2” L x 1 1/2” W. Please remember to disconnect the power to the dryer before starting the repair. This is a genuine OEM part.
Door Seal

$54.35

In Stock

If this part appears to be too wide for your particular appliance, per the manufacturer, all you have to do is pull it apart.