Most Popular Parts
These are the most commonly purchased repair parts for AWM290W.
-
This screw is sold individually.
-
This part is located between the drum support rollers and idler pulley in your dryer to help prevent the parts from bumping up against the brackets they are attached to. If your dryer has a burning smell, is noisy, or will not tumble, you may need to replace the thrust washer. The washer is 3/4 inches in diameter and a is genuine OEM part. It is recommended to disconnect the power to your dryer before you start your repair.
-
Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.
-
The retaining clip goes onto the end of the roller axle and holds the rear wheel onto the axle. If the ring is broken, damaged, making noises, or will not tumble, you will need to replace it. This is a genuine OEM part and is sold individually.
-
This valve has two ports for water to enter. This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.
-
(1)
This triangular main tub bearing assembly is five inches long. It is made of metal.