Most Popular Parts
These are the most commonly purchased repair parts for C206.
-
(1)
The surface burner terminal block kit includes one plastic block, metal bracket, wires, and high-temperature nuts. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This part is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
(1)
The 8” drip bowl, also knows as a drip pan, is located under the burner element to catch anything that may drip or spill over while cooking to make clean up easier. This drip bowl measures 8” in diameter at its widest point at the top, and is chrome in color. This part works with terminal style plug in. This is just the drip bowl; the trim ring is not included must be ordered separately. This is a genuine OEM part and is sold individually.
-
(5)
The door hinge attaches to the side of the door allowing the oven door to open, close, and stay open at an angle. If your door is not opening and closing correctly you may need to replace the hinge. It is recommended to replace both hinges at the same time. The hinge measures 20 1/2-inch and is made of metal. This is a genuine OEM part.
-
(3)
-
(9)
This grease filter is intended for use with some downdraft cooktops and ranges to collect grease particles in the air from cooking. The grease filter is chrome in color, approximately fourteen inches long and almost twelve inches wide. The grease filter is sold individually and is a genuine OEM part.
-
This large surface burner is 2100W.