Most Popular Parts
These are the most commonly purchased repair parts for CDE20T7WC.
-
![Multi Rib Belt - 92-1/4" – Part Number: 341241](https://easyappliancepartscom-evbpg7caa2aehnhz.z01.azurefd.net/assets/partimages/346995_1_M.jpg "Multi Rib Belt - 92-1/4" – Part Number: 341241")
(41)
This dryer drum belt has four ridges, three grooves, 1/4-inch wide and 92 1/4-inch long. The belt helps rotate the drum. If the drum does not rotate and you can still hear the motor running, the belt may have broken and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
-
(2)
The lint filter is used to collect lint and debris as it passes through the dryer vent. It is recommended to clean the lint filter before every load. If your dryer takes too long to dry you may need to replace the filter. This lint filter screen has two side guides on either of the screen. One measures 3/8 of an inch wide, while the other measures 5/8 of an inch wide. This is a genuine OEM part.
-
(1)
This kit comes with three separate thermal fuses and is usually used with clothes dryers that have a fan mounted on the motor shaft. Included within this kit is the high limit (Limit: 258), the gas high limit (Limit: 240), and the gas and electric high limit thermostat (Limit: 300).
-
(2)
This heating element assembly includes the high limit thermostat (L240-80F). The 240-volt 4750-watt, heating element produces heat for drying clothes inside your dryer. If your dryer takes too long to dry or has no heat, you should check for a blown thermal cut out or a thermal fuse. Some heating elements will often have a break in the coil element and will need to be replaced. The element measures approximately 10” L x 3.5” W and the thermostat measures 2” L x 1 1/2” W. Please remember to disconnect the power to the dryer before starting the repair. This is a genuine OEM part.
-
The blower wheel clamp is used to hold the blower wheel to the motor shaft. The clamp is less than an inch long and is used with your dryer. If your blower wheel is loose or making a noise while operating, you may need to replace the clamp. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.
-
This screw is sold individually.