Most Popular Parts
These are the most commonly purchased repair parts for CT19Y4FW.
-
(7)
Door switch turns the light off when you close the door.
-
(31)
This is a replacement ice maker assembly. The ice maker receives water from the water inlet valve and will freeze until ice cubes are formed. Once the water has been frozen the cubes will be ejected from the mold in to the ice bucket. The ice maker will continue the process until the ice bucket has reached the limit. If your ice maker is not making ice you may need to replace this part. Disconnect the power and water supply before starting your repair. This ice maker is a genuine OEM part. NOTE: This part has been updated by the manufacturer and does not include the cover, ice level arm or the wire harness. You can reuse those from the original ice maker.
-
(17)
This condenser fan motor is used with frost-free refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, cooling the compressor and condenser coils. This part also helps to evaporate excess water in the drain pan. If your refrigerator/freezer section is too warm you may need to replace this part. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting the repair.
-
This screw is half an inch long. It is made of metal and is intended for use with ranges, refrigerators, and washing machines.
-
The ice bucket is used to hold the ice cubes in the freezer section that are released from the ice maker until ready to be used. If the bin becomes lost or damaged, you will need to replace the bin. The bin is white in color, made of plastic, and measures approximately 15” x 12”. This is a genuine OEM part.
-
(3)
When energized, the water inlet valve will release water from the supply line into the ice mold and the water dispenser in the refrigerator. If the ice maker is not making/dispensing ice, not dispensing water, or leaking, you may need to replace the water inlet valve. The water inlet valve is in the back section of your refrigerator and will need to be pulled out from the wall. Make sure to disconnect both the water and power supply before starting your repair. The manufacturer has redesigned the valve; it may appear different than the original. The updated valve has a new quick connection. To install the updated valve, cut the retaining nut off the existing water line and gently push into the new valve. This is a genuine OEM part. Please remember to disconnect the power and the water supply before starting your repair.