Westinghouse Range CWEF310GSG
Repairing your CWEF310GSG Westinghouse Range is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
CWEF310GSG model diagrams below. Trust us to help you find the part you need and get your
CWEF310GSG Westinghouse Range running again.
Diagrams for Westinghouse CWEF310GSG Range
There are 4 diagrams for CWEF310GSG. Click on the diagram where you think your part is located.
Most Popular CWEF310GSG Parts
These are the most commonly purchased repair parts for CWEF310GSG.
-
(67)
The bake element is located on the bottom of the oven cavity to supply heat for baking. The element terminals are male quarter inch spade connectors and have push-on wire terminals. If your oven is not heating evenly, the element will not heat, or there is little to no heat when baking, you may need to replace the element. This is a genuine OEM bake element. Please remember to disconnect the power to your oven before you start your repair.
-
![Drip Bowl - 8" – Part Number: 316048413](https://easyappliancepartscom-evbpg7caa2aehnhz.z01.azurefd.net/assets/partimages/437595_1_M.jpg "Drip Bowl - 8" – Part Number: 316048413")
(7)
The eight-inch drip bowl sits under the surface burner element to collect anything that may drip or spill over, to make cleaning up quick. This bowl measures approximately 10-inch in diameter at its widest point at the top. If your drip bowl becomes damaged or rusted it is best to replace the drip bowl to avoid any grease or spills from dripping down inside the range. This chrome drip bowl is compatible with most electric ranges that utilize plug-in surface burners. This is a genuine OEM part and is sold individually.
-
![Chrome Drip Bowl - 6" – Part Number: 316048414](https://easyappliancepartscom-evbpg7caa2aehnhz.z01.azurefd.net/assets/partimages/437596_1_M.jpg "Chrome Drip Bowl - 6" – Part Number: 316048414")
(31)
The 6-inch drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This chrome drip bowl is compatible with electric ranges that utilize plug-in surface burners. This bowl measures approximately 8-inches in diameter. If your drip bowl becomes damaged or rusted it is best to replace the drip bowl to avoid any grease or spill from dripping down inside the range. This is a genuine OEM part and is sold individually.
-
(8)
This surface burner terminal block kit comes with interchangeable mounting brackets, ceramic wire nuts, heat shrink protective tubing and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or is not heating properly, it is likely an issue with the terminal block and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
(16)
This surface burner switch controls the stove top 8-inch surface burner temperature. This switch is 240-volt, 2100-2600 watt, and 8.8-10.8 amp. If your element is not defective but will not heat, you may need to replace the switch. This burner switch is a genuine OEM part. It is recommended to disconnect the power to your range before you start your repair.
-
(5)
This surface burner element is eight inches in diameter. It has five turns, 2600 watts and looped terminal ends. The element provides heat to the cooking surface on your range. If your element is not heating, you may need to replace this part. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. The element is a genuine OEM part. It is sold individually.