Most Popular Parts
These are the most commonly purchased repair parts for EHN3802W,L.
-
(17)
This six-inch chrome drip bowl is compatible with electric ranges that utilize plug-in surface burners. This bowl measures approximately 7 2/3-inch in diameter. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.
-
(9)
This eight-inch chrome drip bowl is intended for use with rolled terminal style plug in surface element units. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.
-
(4)
This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
This plug-in surface burner element has looped terminal ends.
-
(2)
The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean up easier. The measurements for the pan set are 1-1/2-inch x 12-3/4-inch x 16-3/4-inch and is a genuine OEM part.
-
(1)
The bake element can be found at the bottom of the oven and supplies the heat while baking. If your oven is not heating properly, has little or no heat, is too hot, or the element has been burnt out, you will need to replace the element. The element measures approximately 17-inch long, terminals are 21-inch apart with a terminal depth of just 2-inches. Please remember to shut off the power supply to the oven before starting your repair. This bake element is a genuine OEM part.