Most Popular Parts
These are the most commonly purchased repair parts for EHS360.
-
(11)
This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.
-
(4)
This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
(2)
This is a genuine OEM part that is used inside your range/oven to provide a durable surface for your cookware. The rack measures approximately 23 inches wide and 16 inches deep. The part is made of metal and is sold individually.
-
(2)
The broil element is located on the roof of the oven cavity to supply heat for broiling. The element measures approximately 13 1/2-inch wide,19-inch long and 3000 watts. If the broil element is no longer heating or it has shorted out, then you will need to replace your broil element. Please remember to disconnect the power to the oven before starting your repair. This is a genuine OEM part.
-
(2)
The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean up easier. The measurements for the pan set are 1-1/2-inch x 12-3/4-inch x 16-3/4-inch and is a genuine OEM part.
-
(1)
The bake element is located on the bottom of the oven and supplies heat for baking. This part measures 13 1/2-inch long, 18 1/2-inch wide with the depth of the terminals is 3-inch. If your oven is too hot, not heating evenly, the element is not heating, or there is little to no heat when baking you may need to replace your bake element. You can use a multi meter to test the bake element for electrical continuity to see if you need to replace it. This is a genuine OEM part. Please remember to disconnect the power to the range before starting your repair.