Most Popular Parts
These are the most commonly purchased repair parts for EIFLW50LIW1.
-
The water inlet valve gasket helps prevent water from leaking between the water inlet valve and the dispenser drawer housing. If your washer is leaking or filling slowing, the gasket could be worn or damaged and will need to be replaced. The gasket is black in color, made of rubber and measures approximately 3/4” of an inch high. Please remember to disconnect the power and water supply before starting the repair. This is a genuine OEM part.
-
(4)
The door strike attaches to the door of your front load washer and will activate the door switch once the door is closed. If your washer won’t start or the door won’t close/open properly, you may need to replace the door strike. This is a genuine OEM part. Please remember to disconnect the power to the washer before starting your repair.
-
Also known as Door Boot Seal.
-
This is a genuine dispenser drawer assembly, which works with washers.
-
(3)
The water inlet valve attaches the water lines to the back of your washer. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. If your washer won’t stop filling with water, leaking, no hot or cold water or will not fill with water you may need to replace this part. The valve measures approximately 10”, is blue, red, and white in color and made of plastic. This water inlet valve is a genuine OEM part. Please make sure to disconnect the power to your washer before you start your repair.
-
(1)