Electrolux Dryer EWMED65HTS0
Repairing your EWMED65HTS0 Electrolux Dryer is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
EWMED65HTS0 model diagrams below. Trust us to help you find the part you need and get your
EWMED65HTS0 Electrolux Dryer running again.
Diagrams for Electrolux EWMED65HTS0 Dryer
There are 7 diagrams for EWMED65HTS0. Click on the diagram where you think your part is located.
Most Popular EWMED65HTS0 Parts
These are the most commonly purchased repair parts for EWMED65HTS0.
-
(3)
This gray lint filter is used to collect lint and debris as it passes through the dryer vent. It is recommended to clean the lint filter before every load to clear the air flow through the lint filter. If your dryer takes too long to dry or the lint filter becomes damaged, you may need to replace the filter. This lint filter measures 14” wide and 11” high. This is a genuine OEM part.
-
(3)
This 3-coil 5500 watts heating element with housing is used to produce heat to dry the clothes in your dryer. The heating element is strung with a coiled wired. The wire receives, but resists a controlled electric current causing the wire to heat up to dry your clothes. If there is no heat or it is taking too long to dry, you may need to replace the heating element. Check for a blown thermal fuse or thermal cut off. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting the repair.
-
-
-
The two-terminal high limit thermostat has a limit of 260 degrees Fahrenheit and acts as a safety mechanism that keeps the dryer from overheating. The thermostat will cut out when the internal dryer temperature reaches 260 and then cuts back in when the temperature drops by 70 degrees Fahrenheit. If your dryer is not heating, you may need to replace the thermostat. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.
-
