Most Popular Parts
These are the most commonly purchased repair parts for FCE10610B.
-
(11)
This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.
-
(1)
The surface burner terminal block kit includes one plastic block, metal bracket, wires, and high-temperature nuts. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This part is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
(4)
The oven sensor detects the temperature within the oven cavity and sends the information to the control board. If your oven is not heating evenly, has little or no heat when baking, or is too hot, you may need to replace the sensor. This long oven sensor kit comes with two harness adapters and is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
(14)
The bake element is located on the bottom of the oven cavity to supply heat for baking. The element terminals are male spade connectors and have push-on wire terminals. This element measures 19 ¼ inches wide by 15 1/2 inches deep and extends approximately 3 inches past the bracket to the element terminals. If your oven is not heating evenly, the element will not heat or there is little to no heat when baking, you may need to replace the element. This is a genuine OEM bake element. Please remember to disconnect the power to your oven before you start your repair.
-
(2)
This infinite switch for eight inch range burners is almost three inches long. This infinite switch is for 8-inch range burners. When an element is unable to produce any heat on a modern oven, the problem may lie with the infinite switch. This switch is responsible for sending power to the surface elements. Check the element and terminal block to ensure they are working properly. If they are in working order, check the infinite switch at the control panel for any wires that have overheated, or broken terminals to or from the infinite switch. If the infinite switch is damaged or malfunctioning, it will need to be replaced. Remember to unplug your range before beginning this repair.
-
(5)
The oven door gasket prevents heat from escaping the oven cavity when in use by creating a seal around the oven door. If your oven has little or no heat when baking, you may need to replace the gasket. This door gasket contains all the attaching clips needed for installation and is a genuine OEM part. Please make sure the oven is cool before installing the door gasket.