Frigidaire Wall Oven FEB24S2ASB
Repairing your FEB24S2ASB Frigidaire Wall Oven is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
FEB24S2ASB model diagrams below. Trust us to help you find the part you need and get your
FEB24S2ASB Frigidaire Wall Oven running again.
Diagrams for Frigidaire FEB24S2ASB Wall Oven
There are 5 diagrams for FEB24S2ASB. Click on the diagram where you think your part is located.
Most Popular FEB24S2ASB Parts
These are the most commonly purchased repair parts for FEB24S2ASB.
-
(2)
This 40-watt light bulb has a standard screw-in base and is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.
-
(4)
The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is a genuine OEM part. If your oven is too hot, not heating evenly, has little to no heat when baking, or is flashing F3/F4 error messages on your control board, you may need to replace the temperature sensor. Please make sure to disconnect the power to your range before starting your repair.
-
(3)
If your oven is too hot, the element will not heat, or there is little to no heat when baking, you may need to replace your bake element. The 2100-watt element is located on the bottom of the oven and it supplies heat while baking. When replacing the element, make sure to hold the wires forward so the wires do not fall back through the rear of the oven. Please remember to disconnect the power to your oven before starting the repair. This bake element is a genuine OEM part.
-
(7)
This is an oven bulb lens cover. It is made of glass and is approximately 3 inches in diameter. The lens cover protects the light bulb from being damaged. The main reason to replace the light lens cover is if it is cracked, damaged, or missing. Make sure the lens cover is cool to the touch before you begin this repair. To remove the lens cover, simply turn it counter clockwise until you can remove it. Replace it with a new cover and turn it clockwise to lock it into place. This is an OEM part sourced from the manufacturer, and it is sold individually.
-
(1)
This terminal block kit (also called terminal boards or strips) provides a convenient means of connecting individual electrical wires. This kit includes mounting screws and hex nuts and can be used with dryers and ranges. This kit allows you to attach the power cord to the inner wiring of your appliance. If the terminal block is faulty, your appliance will not get the power it needs to operate properly. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
White in color. Overlay only.