Frigidaire Cooktop FEC32C4ACB Sections

There are 4 diagrams for FEC32C4ACB. Click on the diagram where you think your part is located.

CONTROL PANEL

COVER

MAIN TOP

WIRING DIAGRAM

Most Popular Parts

These are the most commonly purchased repair parts for FEC32C4ACB.

Drip Bowl - 8"

$10.10

In Stock

(7)

The eight-inch drip bowl sits under the surface burner element to collect anything that may drip or spill over, to make cleaning up quick. This bowl measures approximately 10-inch in diameter at its widest point at the top. If your drip bowl becomes damaged or rusted it is best to replace the drip bowl to avoid any grease or spills from dripping down inside the range. This chrome drip bowl is compatible with most electric ranges that utilize plug-in surface burners. This is a genuine OEM part and is sold individually.
Chrome Drip Bowl - 6"

$6.00

In Stock

(31)

The 6-inch drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This chrome drip bowl is compatible with electric ranges that utilize plug-in surface burners. This bowl measures approximately 8-inches in diameter. If your drip bowl becomes damaged or rusted it is best to replace the drip bowl to avoid any grease or spill from dripping down inside the range. This is a genuine OEM part and is sold individually.
Terminal Block Kit

$7.54

In Stock

(8)

This surface burner terminal block kit comes with interchangeable mounting brackets, ceramic wire nuts, heat shrink protective tubing and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or is not heating properly, it is likely an issue with the terminal block and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
Burner Switch Kit

$37.34

In Stock

(1)

This burner switch controls the stove top surface burner temperature. If your element will not heat and does not look defective, you may need to replace the switch. This kit includes screws, keeper for mounting, and several insert sizes to match your old knob. This switch kit is a genuine OEM part. It is recommended to disconnect the power to your range before you start your repair.
Burner Knob

$52.23

On Order

(4)

Sold individually. This knob accepts a D-shaped shaft.
Surface Burner Coil Element - 8" - 2100W

$132.61

In Stock

(1)