Most Popular Parts
These are the most commonly purchased repair parts for GBD277PDS4.
-
(11)
This bake element has push-on terminals and is located on the bottom of the oven. It provides heat for baking. If your oven is too hot, not heating evenly, the element is not heating, or there is little to no heat when baking, you may need to replace your bake element. You can use a multi meter to test the bake element for electrical continuity to see if you need to replace it. This is a genuine OEM part. Please remember to disconnect the power to the range before starting your repair.
-
(2)
The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is a genuine OEM part. If your oven is too hot, not heating evenly, has little to no heat when baking, or is flashing F3/F4 error messages on your control board, you may need to replace the temperature sensor. Please make sure to disconnect the power to your range before starting your repair.
-
(5)
The interior oven door glass is the innermost heat resistant piece of glass that faces in your oven when the door is closed. The glass measures approximately 9.99-inchx16.99-inch. If the glass is cracked it should be replaced. This is a genuine OEM part.
-
(1)
Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.
-
The thermostat is used to establish and maintain the internal temperature within the oven cavity. The thermostat will trip when the controls for the oven are not working and the temperature within the oven cavity gets too hot. Once the thermostat trips it cannot be reset, it will need to be reset. This is a genuine OEM part. Please remember to disconnect the power to the oven before starting the repair.
-
This broil element is found on the roof of the oven.