General Electric Washer GTWN4250D0WS
Repairing your GTWN4250D0WS General Electric Washer is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
GTWN4250D0WS model diagrams below. Trust us to help you find the part you need and get your
GTWN4250D0WS General Electric Washer running again.
Diagrams for General Electric GTWN4250D0WS Washer
There are 4 diagrams for GTWN4250D0WS. Click on the diagram where you think your part is located.
Most Popular GTWN4250D0WS Parts
These are the most commonly purchased repair parts for GTWN4250D0WS.
-
(10)
This corrugated drain hose carries the drain water from the washer to the house drain. It is black in color, measures 57-inches long, and both ends of the drain hose can be bent. If your drain hose becomes damaged or cracked, it will cause water to leak on the floor during the wash cycle and you will need to replace the hose. This is a genuine OEM part. Please make sure you shut off the water supply and disconnect the power to the washer before starting your repair. Note: Clip is not included.
-
This part is used to support the tub and keep it in the center of the cabinet to reduce vibration. If your washer is making loud noises, or shakes or moves, one or more of the straps may have broken. It is recommended to replace all 4 tub dampening straps at the same time. This part is sold individually.
-
(13)
This plastic dual action agitator is white in color. It is approximately eighteen inches tall with a base diameter of about 12-1/4 inches. The agitator pivots back and forth, moving the clothes from the top to the bottom of the tub, through the detergent and water to wash them. If the agitator becomes damaged or will not agitate, you may need to replace the part. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.
-
(4)
This part is known as the "brains" of the appliance.
-
(5)
The purpose of the triple water valve is to properly fill your washer with water by controlling the hot and cold water going into the tub. If your washer is overfilling or not filling, you may need to replace this part. It is about 5.5 inches in total length. You will find your water inlet valve at the back of your washer.
-
(3)