Most Popular Parts
These are the most commonly purchased repair parts for ID5HHEXWS03.
-
(83)
This clear crisper drawer with humidity control allows you to adjust the humidity within the crisper. This can extend the life of your produce. Does the drawer measure approximately 7.60 inches in height by 14.92 inches from front to back and 16.50 inches wide. This is a genuine OEM part.
-
(40)
The door bin attaches to the inside of your refrigerator door to hold bottles or jars and can be moved according to space needed. If the door bin is cracked or the mounting tabs have broken off, you will need to replace the bin. The bin is clear with white trim around the top edge. This is a genuine OEM part and is sold individually.
-
(31)
This clear convertible meat drawer can be used to store meats or vegetables. It has its own cold air duct to allow cold air from the freezer to flow into the drawer. You could have a broken or faulty drawer if you find that the food being kept within is spoiling or drying out quickly. The drawer should slide open and closed with ease. If your drawer will not easily slide open or closed, check the tracks that the drawer slides on. If the tracks are not damaged, the drawer itself could be at fault and should be replaced. This part measures approximately 16 7/16 inches wide x 14 5/16 inches deep x 7 5/8 inches high, and is a genuine OEM replacement part. It is sold individually.
-
(7)
This genuine Whirlpool water filter is used in your refrigerator to help reduce contaminants that may be in your household water supply. The water filter measures 2 1/2” in diameter and 10 1/2” long and is in the filter housing inside of your refrigerator. It is recommended to replace the water filter every 6 months for best performance. This water filter will fit all Whirlpool and KitchenAid refrigerators with a water filter located in the base grill below the door. Also, for Kenmore models starting with 106. Filters for taste and odor, sediment, chlorine, lead.
-
(11)
Bucket only. All other parts sold separately. This part holds the ice once it's released from the icemaker.
-
(5)
The thermostat will sense the temperature increase in the evaporator during the defrost cycle and will cycle the defrost heater off after the ice or frost is melted.