Most Popular Parts
These are the most commonly purchased repair parts for JB710ST1SS.
-
(7)
The temperature sensor detects the temperature within the oven cavity. If your oven is too hot, not heating evenly, or has little to no heat when baking, you may need to replace the temperature sensor. The sensor is usually located in the back of the oven. This is a genuine OEM part. Please make sure to disconnect the power to your range before starting your repair.
-
(3)
This part is the replacement surface burner switch or element control switch for your range or cooktop. The burner switch turns the surface element on and off and controls the amount of heat the element produces. If you are unable to start your heating element, or if the temperature is unpredictable, you may have a damaged surface burner switch. Be sure to disconnect your range from the power source or shut off the circuit breaker before repairing this part. It is sold individually and is an OEM part sourced directly from the manufacturer.
-
(1)
-
(1)
The oven door gasket creates a seal between the oven door and the opening of the oven to prevent heat from escaping when the oven is closed.
-
(3)
This is a replacement haliant element for your cooktop or range. It is used with flat top ranges, and is found under the glass top of the range. This element is approximately 12 inches in diameter and is sold individually. The haliant surface element supplies the heat needed to the top of the cooktop. If your burner is not lighting up when it is turned on, you may have an issue with the haliant surface element. Be sure to disconnect power to the range before you begin this repair. To replace the element, remove the screws holding the cooktop in place, then remove it. Remove the screws holding the burner in place, disconnect the wires and replace the burner. Replace the cooktop and screw it back in to complete your repair.
-
(3)
This switch controls the stove top surface burner.