Most Popular Parts
These are the most commonly purchased repair parts for JDR8895ACB.
-
(2)
This part is used to support and keep your range level. You can adjust the height of the leveling leg to help level your range. The leveling leg is black in color and made of plastic. The manufacture has updated this part from the original. This part now measures approximately 1.859" and sold individually. This part is a genuine OEM part. This leg may be shorter than the original but is the factory replacement. Longer leg is not available.
-
(4)
The oven sensor detects the temperature within the oven cavity and sends the information to the control board. If your oven is not heating evenly, has little or no heat when baking, or is too hot, you may need to replace the sensor. This long oven sensor kit comes with two harness adapters and is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
(9)
This part is a replacement halogen lamp for your oven. The bulb is 25 watts and 120 volts. If your light bulb is burned out, this is the part that replaces it. Be sure to turn off power to your range hood before you begin this repair. This bulb is sold individually and is a genuine OEM part sourced directly from the manufacturer.
-
(20)
The bake element is located on the bottom of the oven cavity to supply heat for baking. The element terminals are male quarter inch spade connectors and have push on wire terminals. This element measures 19 inches wide by 20 inches long, including the terminals. If your oven is not heating evenly, the element will not heat, or there is little to no heat when baking, you may need to replace the element. This is a genuine OEM bake element. Please remember to disconnect the power to your oven before you start your repair.
-
(3)
This bake element is found on the bottom of the oven.
-
(8)
This broil element is found on the roof of the oven.