Most Popular Parts
These are the most commonly purchased repair parts for JDS9860AAP.
-
(10)
This genuine OEM bake element has push-on terminal ends and provides heat while baking. If the bake element has arcing, is shorted out, the oven is not heating evenly, or little or no heat when baking, you may need to replace it. When replacing the bake element please make sure you disconnect the power to the range. Make sure you do not let the wires fall back through the rear of the oven. This element has been updated by the manufacturer. New installation screws are required and are sold separately.
-
(9)
This part is a replacement halogen lamp for your oven. The bulb is 25 watts and 120 volts. If your light bulb is burned out, this is the part that replaces it. Be sure to turn off power to your range hood before you begin this repair. This bulb is sold individually and is a genuine OEM part sourced directly from the manufacturer.
-
(4)
The oven sensor detects the temperature within the oven cavity and sends the information to the control board. If your oven is not heating evenly, has little or no heat when baking, or is too hot, you may need to replace the sensor. This long oven sensor kit comes with two harness adapters and is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
(11)
The grease filter is intended for use with some downdraft cooktops and ranges to collect grease particles in the air from cooking. The grease filter is silver in color, approximately 15 1/2” long and almost 6 1/4” wide. As per the manufacturer, the original filter may have been a 1/2” wider, but it should not be a problem and will still function the same. The grease filter is sold individually and is a genuine OEM part.
-
(5)
The oven door gasket prevents heat from escaping the oven cavity when in use by creating a seal around the oven door. If your oven has little or no heat when baking, you may need to replace the gasket. This door gasket contains all the attaching clips needed for installation and is a genuine OEM part. Please make sure the oven is cool before installing the door gasket.
-
(2)
This top burner igniter has a male spade terminal. It is used to create a spark that will light the gas and start the burner when the burner knob is depressed and turned. The mounting bracket is included with the igniter. If your element will not heat, will not start, or the gas igniter glows but will not light, you may need to replace the igniter. This is a genuine OEM part. It is recommended to disconnect the power to your range before you start your repair.