Jenn-Air Range JES9900BAS
Repairing your JES9900BAS Jenn-Air Range is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
JES9900BAS model diagrams below. Trust us to help you find the part you need and get your
JES9900BAS Jenn-Air Range running again.
Diagrams for Jenn-Air JES9900BAS Range
There are 8 diagrams for JES9900BAS. Click on the diagram where you think your part is located.
Most Popular JES9900BAS Parts
These are the most commonly purchased repair parts for JES9900BAS.
-
(11)
This bake element is found on the bottom of the oven. his bake element is for ranges.
The bake element is at the bottom of the oven and supplies the heat for baking.
Unplug the range or shut off the house circuit breaker for the range before installing this part. Wear work gloves to protect your hands.
-
(4)
The oven sensor detects the temperature within the oven cavity and sends the information to the control board. If your oven is not heating evenly, has little or no heat when baking, or is too hot, you may need to replace the sensor. This long oven sensor kit comes with two harness adapters and is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
(5)
This 6 Inch 1200-watt radiant surface element with limiter is located under the main cooktop. When the element is turned on, it will heat up and provide heat to the cooking area on top of the range. If your element will not supply heat you will need to replace it. When replacing the radiant surface element please make sure the element is cool to touch before starting the repair. Disconnect the power to your range before beginning the repair. This is a genuine OEM part.
-
(5)
The oven door gasket prevents heat from escaping the oven cavity when in use by creating a seal around the oven door. If your oven has little or no heat when baking, you may need to replace the gasket. This door gasket contains all the attaching clips needed for installation and is a genuine OEM part. Please make sure the oven is cool before installing the door gasket.
-
Sold individually.
-
(2)
The large surface element is installed under the cooktop and heats up the area directly above it. It is approximately 10 inches in diameter and is 1200/2500 watts. If your element is not heating up, you may need to replace the element or check the burner switch. This part a genuine OEM part. Please remember to disconnect the power to your range before starting your repair.