General Electric Wall Oven JRP28SK1SS

Repairing your JRP28SK1SS General Electric Wall Oven is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the JRP28SK1SS model diagrams below. Trust us to help you find the part you need and get your JRP28SK1SS General Electric Wall Oven running again.

Diagrams for General Electric JRP28SK1SS Wall Oven

There are 5 diagrams for JRP28SK1SS. Click on the diagram where you think your part is located.

BODY PARTS

CONTROL PANEL

DOOR

DOOR LOCK

LOWER DOOR

Most Popular JRP28SK1SS Parts

These are the most commonly purchased repair parts for JRP28SK1SS.

Single Heating Element Support Clip

$13.67

In Stock

(3)

The support clip is used to hold the broil element in place at the top of the oven cavity. If the clip is broken or damaged, you will need to replace the part. The support clip is made of metal, is a little over an inch long, and is sold individually. This is a genuine OEM part.
Bake Element

$66.73

In Stock

(6)

This bake element is found on the bottom of the oven.
Broil Element - 240V

$81.25

In Stock

(3)

The broil element with push-on terminals is located on the roof of the oven cavity to supply heat for broiling. If the element is no longer heating or has shorted out, you will need to replace your broil element. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.
Oven Sensor

$139.45

In Stock

(4)

The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is a genuine OEM part. If your oven is too hot, not heating evenly, has little to no heat when baking, or is flashing F3/F4 error messages on your control board, you may need to replace it. Make sure to disconnect the power to your range before starting your repair.
Oven Rack

$34.53

In Stock

(2)

Sold individually.
Broiler Pan - Large

$28.45

In Stock

The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below making clean up easier. This part is gray in color, made of enameled porcelain for an easy-to-clean, durable and made to last. The pan measures approximately 17” wide by 13” deep, insert measures 15 1/2” wide by 13” deep. This is a genuine OEM part.