General Electric Microwave JVM1790SK01
Repairing your JVM1790SK01 General Electric Microwave is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
JVM1790SK01 model diagrams below. Trust us to help you find the part you need and get your
JVM1790SK01 General Electric Microwave running again.
Diagrams for General Electric JVM1790SK01 Microwave
There are 8 diagrams for JVM1790SK01. Click on the diagram where you think your part is located.
Most Popular JVM1790SK01 Parts
These are the most commonly purchased repair parts for JVM1790SK01.
-
(3)
This clear 20-watt, 120-volt halogen light bulb is a replacement part for the bulb behind the top grill in your microwave. The light bulb is used on the inside of your microwave to provide light when the door is open, or below the microwave to provide light for the cooking area. If the bulb in the microwave is burnt out or broken you will need to replace it. This is a genuine OEM halogen light bulb and is sold individually.
-
(1)
This is the replacement monitor switch for your microwave. It is black in color and measures approximately 1 inch by ¾ of an inch. This switch monitors the door latch position of your microwave and communicates to the electronic control board whether the latch is open or closed. If the switch is damaged, your microwave may not start, even though the door latch is closed. You can check the continuity of the switch by using a multimeter. Be sure to disconnect the microwave from power before you begin this repair.
-
(2)
The line fuse, also known as a ceramic fuse, is used to protect your microwave when there is a power serge by shutting down the microwave to avoid damage. If your microwave has no heat, won’t turn on, or the touch pad is not working properly, you may need to replace the fuse. This part measures approximately 1.25” long and is sold individually. Please remember to disconnect power to the microwave before starting the repair. This is a genuine OEM part.
-
(1)
The grease filter can be found on the bottom of the microwave. If your grease filter is damaged, it will not effectively capture grease that builds up when your microwave is in use. To replace the grease filter, simply grasp the filter ring and push it to the back of the microwave, then lift out the filter. To preserve the life of your grease filter, you should occasionally remove them and gently wash them in a warm water and detergent solution. Most microwaves will have two grease filters, but this part is sold individually. The grease filter is approximately 8.5 inches by 5 inches.
-
-
(2)
Sold Individually.