Jenn-Air Washer JW1000AKW
Repairing your JW1000AKW Jenn-Air Washer is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
JW1000AKW model diagrams below. Trust us to help you find the part you need and get your
JW1000AKW Jenn-Air Washer running again.
Diagrams for Jenn-Air JW1000AKW Washer
There are 7 diagrams for JW1000AKW. Click on the diagram where you think your part is located.
Most Popular JW1000AKW Parts
These are the most commonly purchased repair parts for JW1000AKW.
-
This screw is sold individually.
-
(2)
This V-style drive belt is about 51-inch long and 3/8-inch wide. This part is made to slip onto the motor pulley to bring the basket up to the speed required. The belt encounters wear and tear over time. If your washer will not drain, spin, or agitate, you may need to replace your belt. It is recommended to disconnect the power to your washer before you start your repair. This V-style belt is a genuine OEM part.
-
(2)
This drain pump with pulley has 2 ports. The pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period. If your washer will not drain, is noisy, leaking or has a burning smell, you may need to replace the drain pump. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.
-
The transmission pulley and bearing kit, also known as a thrust bearing kit, is located on the drive shaft. If your washer won’t agitate during use, drum won’t drain, or there is a loud noise during operation, you may need to replace this part. A worn bearing also causes slow spinning or no spin at all. This kit includes the pulley that rotates to spin the tub, washer, and thrust bearing that fits between the pulley and the transmission shaft, 2 upper race washers, 1 lower race washer and the instruction sheet. This is a genuine OEM kit; the parts are not available separately. Please remember to disconnect the power and water supply to the washer before starting the repair.
-
This transmission lip seal repair kit comes in two pieces: a red four inch long piece, and a black one inch long piece. Both pieces are made entirely of plastic. This repair kit comes with and instructions sheet and it is used for some washing machines.
-
The lid hinge pin allows the lid to pivot open and closed correctly. This part is the male end of the lid hinge. If the lid is not opening or closing properly you may need to replace the lid hinge pin on your washer. This lid hinge pin is just over an inch long. It is all white in color and is made entirely of plastic.