Most Popular Parts
These are the most commonly purchased repair parts for LDF6920ST.
-
The rack roller with axle attaches to the upper rack to allow you to move the dishrack in and out with ease along the support rails. The rollers and axles sometimes wear out at the same rate and the manufacturer recommends replacing the axles in pairs. This part is gray in color, made of plastic, and measures 1 1/2” wide. This is a genuine OEM part and is sold individually.
-
(1)
The door hinge cable works in conjunction with the dishwasher door by connecting the door hinge to the door spring and helping to support and balance the weight of the door as you open and close it. If your dishwasher door isn’t closing properly you will need to replace this part. This part measures approximately 12” and is black and white in color. This is a genuine OEM part.
-
(1)
The lower rack roller and axle attaches to the rack and allows you to slide the lower dish rack in and out smoothly. If a roller becomes damaged or broken it will need to be replaced. This part measures approximately 2 1/2” in diameter, gray in color, made from plastic, and is sold individually. This is a genuine OEM part.
-
(1)
The diverter motor works in conjunction with the spray arms in your dishwasher by controlling the flow of water to the spray arms. The motor turns the check valve inside the pump to avert the flow of water between the drain pump and the spray arms. If the motor fails it will cause the dishwasher not to wash or drain and will need to be replaced. This diverter motor is 120 volts and 60 Hz. Please remember to disconnect the power and water supply to the dishwasher before starting the repair. This is an authorized OEM part.
-
The circulation pump is used in both washers and dishwashers. In the washer, the pump is used to circulate the water during operation. In the dishwasher, the pump is used to drain the water from the dishwasher. If the circulation pump stops working, it will prevent the washer and dishwasher from working properly and will need to be replaced. This circulation pump is 120 volts, 60Hz and 30 watt and a genuine OEM part. Please remember to disconnect the power and water supply before starting your repair.
-
The circulation pump mesh filter is used in your dishwasher to avoid food particles from entering the pump during the wash cycle and prevent the pump from getting clogged. The filter also helps support the lower spray arm. If the mesh filter gets torn or clogged beyond cleaning, it will cause the dishwasher to have dirty water or low water pressure and will need to be replaced. The filter measures 10” in diameter. This is a genuine OEM part. Please remember to shut off the power and water supply before starting the repair.