Most Popular Parts
These are the most commonly purchased repair parts for MAH14PDSAW.
-
(1)
The adjustable leveling leg is used to support and keep your washer level. It also allows you to adjust the height of your washer. If your washer is shaking, vibrating, or moving during operation you may need to replace this part. This part has a rubber foot, almost 3” long and is made of metal and rubber. This is a genuine OEM part and is sold individually.
-
This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.
-
This kit contains a flat drive belt, two motor isolators, and an instructions sheet. The drive belt is made to slip on the pulley until the basket gets up the desired speed.
-
This kit comes with grease, earlier lip seal, revised lip seal, o-ring, seal tool, and washer kit.
Used primarily on front load washers.
NOTE: Bearing is NOT sold separately. It is only available with the outer tub assembly.
-
(1)
This hose can handle hot or cold water and is five feet long.
-
This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.