Most Popular Parts
These are the most commonly purchased repair parts for MDG9420BWW.
-
(13)
This drum support roller includes one drum roller and two washer bearings. The drum support roller holds the drum in place while the drum rotates on the support wheels. If the dryer is making a loud rumbling noise or will not tumble, you may need to replace the roller. Most dryers use two drum rollers, and it is recommended to change both at once. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting the repair.
-
(7)
This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If there is no heat or your drying time is getting longer, the coils may be bad and will need to be replaced. Once the coils go bad they do not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
-
(3)
The front glide helps the drum rotate smoothly and quietly while operating. If your dryer will not tumble or is noisy, the glide could be worn down, causing a metal on metal noise, and will need to be replaced. It is recommended to replace both glides at the same time; a rivet tool is required for this installation. This kit includes a blue plastic glide, a brown cork pad, and two metallic rivets. The front drum glide kit is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.
-
(9)
This is a rectangle shaped lint filter screen used for some gas and electric clothes dryers. The dimensions of this lint filter screen are approximately twelve and a half inches long by seven and three quarter inches wide. This is a white filter and the screen is made of white nylon mesh.
-
(4)
At 91-5/8 inches in length, this dryer drum belt from Maytag has five ridges. It is all black in color and is made entirely of rubber. This flat belt is 3/8 of an inch wide.
-
This part senses if the igniter is hot enough to ignite the flame for heat, allowing the gas valve to open. The sensor is three inches long and is used for many gas clothes dryers. If your dryer is not creating any heat, taking too long to dry or shuts off too soon, you may need to replace the flame sensor. This is a genuine OEM part and is made of both plastic and metal. Please remember to disconnect power to your dryer before starting your repair.