Most Popular Parts
These are the most commonly purchased repair parts for MGR6875ADS.
-
(9)
This part is a replacement halogen lamp for your oven. The bulb is 25 watts and 120 volts. If your light bulb is burned out, this is the part that replaces it. Be sure to turn off power to your range hood before you begin this repair. This bulb is sold individually and is a genuine OEM part sourced directly from the manufacturer.
-
(5)
This bake or broil igniter ignites the gas for the oven burner by glowing white. If any of the following symptoms occur, it is best to replace this part: little to no heat when baking, oven will not turn on, gas igniter glows, but does not light up or element will not heat. *Tip: Match up the connecter with the old part. Refer to the manual provided by the manufacturer for installation instructions and accurate guidance. As a safety precaution, remember to unplug your appliance from the power source.
-
(5)
The oven door gasket prevents heat from escaping the oven cavity when in use by creating a seal around the oven door. If your oven has little or no heat when baking, you may need to replace the gasket. This door gasket contains all the attaching clips needed for installation and is a genuine OEM part. Please make sure the oven is cool before installing the door gasket.
-
(3)
The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is 3 inches in length and is a genuine OEM part. If your oven is too hot, not heating evenly, or has little to no heat when baking, you may need to replace the temperature sensor. Please make sure to disconnect the power to your range before starting your repair.
-
(1)
This top burner igniter is used to create a spark that will light the gas and start the burner when the burner knob is depressed and turned. The mounting bracket is included with the igniter. If your element will not heat, will not start, or the gas igniter glows but will not light, you may need to replace the igniter. This top burner igniter is a genuine OEM part. It is recommended to disconnect the power to your range before you start your repair.
-
(1)
The terminal block provides a way of connecting individual electrical wires and offers protection from electrical surges, voltages and currents. This part will also allow you to attach the power cord to the inner wiring of your range. If the terminal block has shorted out or the range is not getting the proper power, this part will need to be replaced. The nuts are not included with the terminal block, they must be ordered separately. This is a genuine OEM part. Please remember to disconnect the power to the range before starting the repair.