Most Popular Parts
These are the most commonly purchased repair parts for PDGT910AWW.
-
This dryer drum belt has five ridges, 93-3/8 inches in length, and 3/8 of an inch wide. It is flat, black in color, and is made entirely of rubber. The belt helps rotate the drum. If the drum does not rotate and you can still hear the motor running, the belt may have broken and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
-
(1)
This single drum support roller is used for square-ported model clothes dryers. It has a metallic bearing in its center. This support roller is used to hold the drum in place in the cabinet while letting the drum rotate on the support rollers. If your dryer is noisy, will not tumble, or takes too long to dry, you might need to replace the roller. It is recommended that you replace both rollers at once. It is sold individually.
-
The drum glide helps the front drum rotate smoothly and quietly while operating. If your dryer will not tumble or is noisy, the glide could be worn down, causing metal on metal noise. In this case, it will need to be replaced. It is recommended to replace both glides at the same time and two are required for the dryer. The drum glide is a genuine OEM part and is sold individually. Please remember to disconnect the power to the dryer before starting your repair.
-
This part senses if the igniter is hot enough to ignite the flame for heat, allowing the gas valve to open. The sensor is three inches long and is used for many gas clothes dryers. If your dryer is not creating any heat, taking too long to dry or shuts off too soon, you may need to replace the flame sensor. This is a genuine OEM part and is made of both plastic and metal. Please remember to disconnect power to your dryer before starting your repair.
-
(1)
This part replaces older two terminal switches.
-
(4)
Note: This part no longer comes with the felt seal. This filter collects lint as it passes through the dryer vent.