Frigidaire Wall Oven PLEB30T8CCB
Repairing your PLEB30T8CCB Frigidaire Wall Oven is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
PLEB30T8CCB model diagrams below. Trust us to help you find the part you need and get your
PLEB30T8CCB Frigidaire Wall Oven running again.
Diagrams for Frigidaire PLEB30T8CCB Wall Oven
There are 6 diagrams for PLEB30T8CCB. Click on the diagram where you think your part is located.
Most Popular PLEB30T8CCB Parts
These are the most commonly purchased repair parts for PLEB30T8CCB.
-
(2)
This 40-watt light bulb has a standard screw-in base and is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.
-
(4)
The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is a genuine OEM part. If your oven is too hot, not heating evenly, has little to no heat when baking, or is flashing F3/F4 error messages on your control board, you may need to replace the temperature sensor. Please make sure to disconnect the power to your range before starting your repair.
-
(5)
The 3000W bake element is located on the bottom of the oven cavity to supply heat for baking. The element terminals are male quarter inch spade connectors and have push-on wire terminals. If your oven is not heating evenly, the element will not heat, or there is little to no heat when baking, you may need to replace the element. This genuine OEM bake element. Please remember to disconnect the power to your oven before you start your repair.
-
(7)
This is an oven bulb lens cover. It is made of glass and is approximately 3 inches in diameter. The lens cover protects the light bulb from being damaged. The main reason to replace the light lens cover is if it is cracked, damaged, or missing. Make sure the lens cover is cool to the touch before you begin this repair. To remove the lens cover, simply turn it counter clockwise until you can remove it. Replace it with a new cover and turn it clockwise to lock it into place. This is an OEM part sourced from the manufacturer, and it is sold individually.
-
The broil element is located on the roof of the oven cavity to supply heat for broiling. If the element is no longer heating or it has shorted out, you will need to replace your broil element. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
This oven door gasket prevents heat from escaping the oven cavity when in use. It contains all of the attaching clips needed for installation.