Most Popular Parts
These are the most commonly purchased repair parts for TANKMAN50.
-
This cooktop cleaner will cut through tough grease and baked-on residue. The cleaner will leave a protective coating of silicone on the cooktop surface as it cleans. This 10oz bottle is safe for all glass, porcelain, and ceramic cooktops. Just apply a small amount to your cooktop and use a circular motion by using a sponge or a rag and gently press until the grease or baked residue has been removed. Please remember to wear gloves to protect your hands while working with the cooktop cleaner.
-
(1)
The light bulb helps illuminate the inside of your oven cavity when the door is open. The bulb is 25 watts and 120 volts. If the light does not come on when the door opens, the bulb could be burnt out and will need to be replaced. It is recommended to order a spare as this is a common wear part. This is a genuine OEM part and is sold individually. Please wear gloves during replacement if your existing bulb is shattered.
-
(1)
The meat probe sensor is used to cook more accurately by checking the internal temperature of the meat to ensure proper temperature is reached during cooking. If the meat probe sensor shorts out it can cause the wrong information to the control board and the sensor will need to be replaced. This part is brown in color and approximately 25 inches. This is a genuine OEM part. Please remember to disconnect the power to the range before starting your repair.
-
This screw is half an inch long. It is made of metal and is intended for use with ranges, refrigerators, and washing machines.
-
This is just the receptacle. Meat probe is sold separately.
-
(1)
This part is the replacement door gasket for your oven. It is made of gray rubber and is sold individually. The door gasket runs along the circumference of the oven door and creates a seal that insulates the oven and keeps heat in. If your oven will not heat up properly, or if you notice that the door gasket has become loose or worn, it may need to be replaced. To replace the door gasket, you will need to remove the retaining bracket at the bottom of the oven door, then carefully pull the gasket away from the front of the oven cavity. Then, push the new gasket inside the groove on the outside of the oven cavity, securing it with the arrowhead fasteners that are built in to the oven cavity. This is an OEM part from the manufacturer.