Tappan Washer TWX645RBD4
Repairing your TWX645RBD4 Tappan Washer is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
TWX645RBD4 model diagrams below. Trust us to help you find the part you need and get your
TWX645RBD4 Tappan Washer running again.
Diagrams for Tappan TWX645RBD4 Washer
There are 6 diagrams for TWX645RBD4. Click on the diagram where you think your part is located.
Most Popular TWX645RBD4 Parts
These are the most commonly purchased repair parts for TWX645RBD4.
-
Sold individually.
-
The agitator is used in top-loading washing machines to help move the clothes around by rotating back and forth through the detergent and water to wash them. If your agitator won’t agitate or is damaged it will need to be replaced. The agitator is approximately 19” tall with a base diameter of about 13”, white in color and made of plastic. The hub has been changed from a hex to a spline. The agitator drive block and cap must be ordered separately. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.
-
(2)
This drive belt is designed to ride on the pulley until the basket gets up to speed. If your washer drum will not agitate or spin, you may need to replace your belt. It is recommended to disconnect the power to your washer and shut off the water supply before you start your repair. This drive belt is a genuine OEM part.
-
(2)
Use this with either a top load or front load washer. This pump has an horizontal mount.
-
This tub seal helps prevent any leaking around the transmission of your washer. If your washer is leaking you may need to replace the seal. The tub seal is located on the bottom of the outer tub, in the center where the transmission comes through to connect to the agitator. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.
-
(1)
The agitator drive block works in conjunction with the agitator in your washing machine by rotating the agitator assembly. If your washer is noisy and not agitating, you may need to replace the drive block because it may be worn out. This part is located between the agitator and the transmission shaft, measures approximately 2” long and is made of metal. This is a genuine OEM part. Please remember to disconnect the power and water supply before beginning your repair.