Most Popular Parts
These are the most commonly purchased repair parts for WPRE6150K2WT.
-
(10)
This corrugated drain hose carries the drain water from the washer to the house drain. It is black in color, measures 57-inches long, and both ends of the drain hose can be bent. If your drain hose becomes damaged or cracked, it will cause water to leak on the floor during the wash cycle and you will need to replace the hose. This is a genuine OEM part. Please make sure you shut off the water supply and disconnect the power to the washer before starting your repair. Note: Clip is not included.
-
This part is used to support the tub and keep it in the center of the cabinet to reduce vibration. If your washer is making loud noises, or shakes or moves, one or more of the straps may have broken. It is recommended to replace all 4 tub dampening straps at the same time. This part is sold individually.
-
(2)
The tub seal helps prevent any leaking around the transmission of your washer outer tub. If your washer is leaking you may need to replace the seal. The tub seal is located on the bottom of the outer tub, in the center where the transmission comes through to connect to the agitator. This is a genuine OEM part. It is suggested to have it installed by a qualified technician because the seal can be difficult to replace. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.
-
(3)
This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear.
-
This part is used to keep your tub upright and somewhat level during the different cycles.
-
This part is the replacement pressure switch, also known as the water-level pressure switch, for your washer. It is round and red on one side, and white with gold terminals on the other. The pressure switch senses and controls the water level in the washer. Once the washer has filled up to the appropriate level, it will allow the washer to move forward in the wash cycle. If it is defective, your washer will either not fill with water, or will not stop filling with water. Before you do this repair, be sure to disconnect your water from the power source, as well as the water source. This part is sold individually and is an OEM part from the manufacturer.