Whirlpool Refrigerator WRS322FDAM04
Repairing your WRS322FDAM04 Whirlpool Refrigerator is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
WRS322FDAM04 model diagrams below. Trust us to help you find the part you need and get your
WRS322FDAM04 Whirlpool Refrigerator running again.
Diagrams for Whirlpool WRS322FDAM04 Refrigerator
There are 14 diagrams for WRS322FDAM04. Click on the diagram where you think your part is located.
Most Popular WRS322FDAM04 Parts
These are the most commonly purchased repair parts for WRS322FDAM04.
-
(83)
This clear crisper drawer with humidity control allows you to adjust the humidity within the crisper. This can extend the life of your produce. Does the drawer measure approximately 7.60 inches in height by 14.92 inches from front to back and 16.50 inches wide. This is a genuine OEM part.
-
(41)
The door bin attaches to the inside of your refrigerator door to hold bottles or jars and can be moved according to space needed. If the door bin is cracked or the mounting tabs have broken off, you will need to replace the bin. The bin is clear with white trim around the top edge. This is a genuine OEM part and is sold individually.
-
(4)
-
(31)
This clear convertible meat drawer can be used to store meats or vegetables. It has its own cold air duct to allow cold air from the freezer to flow into the drawer. You could have a broken or faulty drawer if you find that the food being kept within is spoiling or drying out quickly. The drawer should slide open and closed with ease. If your drawer will not easily slide open or closed, check the tracks that the drawer slides on. If the tracks are not damaged, the drawer itself could be at fault and should be replaced. This part measures approximately 16 7/16 inches wide x 14 5/16 inches deep x 7 5/8 inches high, and is a genuine OEM replacement part. It is sold individually.
-
(10)
-
(5)
The replacement ice maker does not include a new ice level arm, or wire harness, these components will need to be reused from original ice maker.