Most Popular Parts
These are the most commonly purchased repair parts for WRT5B1EW4.
-
(2)
The door rack shelf bar has the end caps to attach it to the door already attached to the end of the bar.
-
This cold control thermostat cycles on and off regularly to keep your refrigerator cold.
-
(1)
This 60Hz 120V defrost timer will cycle for thirty minutes after every eight hours of run time. You can turn the dial on the defrost timer clockwise to be able to advance it in and out of defrost mode. The defrost timer helps melt away any ice that may have built up on the evaporator coils. If your refrigerator/freezer is too warm or too cold, will not advance into the defrost cycle, freezer will not defrost, or it runs too long, the defrost timer may be defective and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to the refrigerator before starting your repair.
-
(3)
This kit includes the motor, clips and terminal connectors. This part has been updated by the manufacture.
This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.
-
If your refrigerator or freezer is too warm or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate the cold air into the refrigerator and freezer sections. The fan blade is white in color and made from plastic. This is a genuine OEM part. Please be sure to disconnect the power to your refrigerator before starting your repair.
-
This part is the replacement door rack for your refrigerator freezer. It is made of white plastic and is approximately 23 inches by 5 inches in size. The door rack connects to your freezer door and allows you to store items on the door shelf, without the items falling out when you open or close the door. The main reason to replace the door rack would be if it is cracked, broken, or missing. To replace the door rack, carefully pop it out of the guide holes in the freezer door and snap the new rack into place. This part is sold individually and is a genuine OEM part.