Amana Dryer Drums and Tubs

Drum Glide

Part Number: WP37001298

The drum glide helps the front drum rotate smoothly and quietly while operating. If your dryer will not tumble or is noisy, the glide could be worn down, causing metal on metal noise. In this case, it will need to be replaced. It is recommended to replace both glides at the same time and two are required for the dryer. The drum glide is a genuine OEM part and is sold individually. Please remember to disconnect the power to the dryer before starting your repair.

Two-Piece Split Ring Bearing

1 Review

Part Number: 279441

This is a replacement bearing ring kit for your dryer. The bearing rings are found on the top and bottom lips of the dryer drum. If your dryer is unusually noisy, or the drum will not turn during operation, or if there are marks left on your clothes after a cycle, you may need to replace the bearing ring kit. The kit comes with 2 bearings, one for the top and one for the bottom of the dryer drum. Remove the front panel of your dryer to access the dryer drum for this repair. At this point you can use a pair of needle nose pliers to release the old bearing rings from the drum. Snap the new bearing rings on, and reassemble the dryer to complete your repair.

Cylinder Glide Bracket

Part Number: WP37001036

These brackets support each side of the tub. Order quantity needed.

Drying Rack - Dimples 9.5" apart

1 Review

Part Number: 3404351

This Whirlpool/Kenmore made dryer drying rack is great for drying shoes and other items that cannot tumble dry. This dryer rack fits whirlpool made dryers that are 29 inches wide, have the letter "E" following the numbers in the model number, and whose dimples are nine and a half inches apart in the back of the dryer drum.

Tall Drum Baffle

Part Number: WP692490

Sold Individually - Appliance originally takes 2.

Baffle, Drum

Part Number: WPW10113136

Front Glide Kit

Part Number: 12002126

This kit includes 2 glides (left and right), 2 pads with adhesive backing and 1 support brace.

Bearing Ring

Part Number: WP3394508

Fits around the front of the drum.

Drum Front Bearing Ring

Part Number: WP3394509

This part mounts to the front of the drum.

Drying Rack

1 Review

Part Number: 3406839

This dryer drying rack is great for drying shoes and other items that cannot tumble dry. This dryer rack fits dryers that are 29 inches wide, have the letter "E" following the numbers in the model number, and whose dimples are four and a half inches apart in the back of the dryer drum.