Crosley Range Switches

Infinite Burner Switch

15 Reviews

Part Number: 316436001

This surface burner switch controls the stove top 8-inch surface burner temperature. This switch is 240-volt, 2100-2600 watt, and 8.8-10.8 amp. If your element is not defective but will not heat, you may need to replace the switch. This burner switch is a genuine OEM part. It is recommended to disconnect the power to your range before you start your repair.

Infinite Burner Switch - Small Element - 240V

1 Review

Part Number: 316436000

This surface burner switch controls the temperature of the stove top 6-inch surface burner. This switch is 240-volt, 1250-1500 watt, and 5.2-6.25 amp. If your element will not heat and is not defective, then you may need to replace the switch. This burner switch is a genuine OEM part. It is recommended to disconnect the power to your range before you start your repair.

Range Infinite Burner Switch - 8 Inch

2 Reviews

Part Number: WP7403P239-60

This infinite switch for eight inch range burners is almost three inches long. This infinite switch is for 8-inch range burners. When an element is unable to produce any heat on a modern oven, the problem may lie with the infinite switch. This switch is responsible for sending power to the surface elements. Check the element and terminal block to ensure they are working properly. If they are in working order, check the infinite switch at the control panel for any wires that have overheated, or broken terminals to or from the infinite switch. If the infinite switch is damaged or malfunctioning, it will need to be replaced. Remember to unplug your range before beginning this repair.

Dual surface element switch

1 Review

Part Number: 316238201

This switch controls the stove top surface burner. This surface element control switch is for ranges. Surface element control switch turns the surface element on and off and controls how much heat the element produces. Unplug the range or shut off the house circuit breaker for the range before installing this part.

Spark Ignition Switch Assembly with Wire Harness

Part Number: 316580611

Four switches are included with the assembly.

Infinite Burner Switch - 8" - 240V

Part Number: 318293811

This switch controls the stove top surface burner.

Spark Ignition Switches with Wire Harness

Part Number: 316580615

Dual Surface Burner Switch

Part Number: WP74003122

This part has been updated by the manufacturer. This updated part now has 7 wire terminals instead of 5. The terminals are all labeled, however, the new switch needs to be tested before connecting the pilot lamp wire (P). To test the new switch: 1) Connect the Line Wires (L1 and L2), connect the Load Wires (H1 and H2). 2) Do not connect the pilot lamp (P) wire yet. 3) Reconnect the power to the range and turn on the new switch and one other switch. 4) Connect the leads of a volt meter on L1 of the new switch and P of the other switch you turned on. 5) If the volt meter reads 220V, the L1 and L2 wires on the new switch must be reveresed. 6) Disconnect power, reverse Line Wires if needed and connect the P wire. 7) Reconnect power to the range after reassembly.

SWITCH

Part Number: 318293810

Oven Door Light Switch

Part Number: 316445500