Electrolux Dryer Parts

Belt

Part Number: 134719300

ROLLER KIT

Part Number: 5304523155

The dryer drum support roller with clip helps hold the drum in place while the drum rotates on the support wheels. Over time the bearings can wear out, causing them to make a squeaking sound while the dryer drum turns. The manufacturer recommends replacing both rollers at the same time. Please remember to disconnect the power to the dryer before starting this repair. This is an OEM part.

Lint Filter

1 Review

Part Number: 134793600

This gray lint filter is used to collect lint and debris as it passes through the dryer vent. It is recommended to clean the lint filter before every load to clear the air flow through the lint filter. If your dryer takes too long to dry or the lint filter becomes damaged, you may need to replace the filter. This lint filter measures 14” wide and 11” high. This is a genuine OEM part.

MOTOR

2 Reviews

Part Number: 5304529782

This dryer drum drive motor with pulley for drum belt has reverse threads for the blower wheel. This is a genuine OEM part.

Blower Wheel and Housing

Part Number: 134690800

Thermal Fuse

Part Number: 134711401

This non-reset-able flush mounted thermal fuse shuts off the power to the motor if the dryer over heats. If the fuse is blown you will need to replace it since it can not be reset. The thermal fuse mounts on to the vent tube. Please remember to disconnect the power before starting the repair. This is a genuine OEM part.

Dryer Heater Element

2 Reviews

Part Number: 134792700

This 3-coil 5500 watts heating element with housing is used to produce heat to dry the clothes in your dryer. The heating element is strung with a coiled wired. The wire receives, but resists a controlled electric current causing the wire to heat up to dry your clothes. If there is no heat or it is taking too long to dry, you may need to replace the heating element. Check for a blown thermal fuse or thermal cut off. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting the repair.

High Limit Thermostat

Part Number: 3204267

The two-terminal high limit thermostat has a limit of 260 degrees Fahrenheit and acts as a safety mechanism that keeps the dryer from overheating. The thermostat will cut out when the internal dryer temperature reaches 260 and then cuts back in when the temperature drops by 70 degrees Fahrenheit. If your dryer is not heating, you may need to replace the thermostat. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.

Rear Drum Bearing Kit

7 Reviews

Part Number: 5303281153

This rear drum bearing kit includes one bearing, one ball shaft, one ball bearing, one ball bearing retainer, a small tube of high temperature lubricant, and installation screws. The support bearing helps support the dryer drum to rotate quietly and smoothly during operation. The bearing attaches on the inside of the rear panel of the dryer cabinet. Over time the drum bearing will wear out. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.

Moisture Sensor

1 Review

Part Number: 134786100