Frigidaire Washer Seals and Gaskets

Bellow Kit

1 Review

Part Number: 134515300

Also known as a Door Boot Seal and is used in front load washers. This part is used to keep the clothes inside the tub during the wash cycle. The folds in the bellow allow the tub to move separately from the door during the spin cycle. NOTE: This part has been redesigned by the manufacturer and is interchangeable with the old design.

Tub Seal Assembly

Part Number: 5303279394

This tub seal helps prevent any leaking around the transmission of your washer. If your washer is leaking you may need to replace the seal. The tub seal is located on the bottom of the outer tub, in the center where the transmission comes through to connect to the agitator. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.

High Temperature Adhesive

Part Number: 5308027429

The high temperature adhesive is used to create a heat resistant bond between felt seals and rubber gaskets on your appliance. This adhesive is made to withstand hot temperatures. This tube contains one ounce of adhesive. Before starting your repair, it is recommended to wear gloves and ensure that your working area is clean and dry.

Dispenser Inlet Gasket

Part Number: 134371300

The water inlet valve gasket helps prevent water from leaking between the water inlet valve and the dispenser drawer housing. If your washer is leaking or filling slowing, the gasket could be worn or damaged and will need to be replaced. The gasket is black in color, made of rubber and measures approximately 3/4” of an inch high. Please remember to disconnect the power and water supply before starting the repair. This is a genuine OEM part.

Bellow Kit

Part Number: 134728400

Also known as a Boot Seal and is used in front load washers. This part is used to keep the clothes inside the tub during the wash cycle and to prevent water from leaking. The folds in the bellow allow the tub to move separately from the door during the spin cycle.

Bellow with Clamp

Part Number: 5303937187

Also known as the door boot seal. This part is used to keep the clothes inside the tub during the wash cycle. The folds in the bellow allow the tub to move separately from the door during the spin cycle.

Gasket

1 Review

Part Number: 3206246

O-ring,overflow tube

Part Number: 134372200

Upper Lip Seal

Part Number: 5303161307

This seal goes on top of the transmission below the agitator drive block.

O-Ring/Gasket

Part Number: 134146100

This part is between the front and rear outer tubs.