General Electric Dishwasher Hoses and Tubes

CONDUIT MID Assembly

1 Review

Part Number: WD22X10094

Pump Filter Coupler

1 Review

Part Number: WD01X10342

This coupler, also known as a hose connector, is made of white plastic and is about one inch in height, and just over one inch in length. Replacing the coupler is a fairly easy repair. The hardest part of the repair is accessing the spray arm and filter to remove them, in order to replace the coupler. In order to complete this repair, you will need a flat head screwdriver and a 4-inch nut driver.

CONDUIT MID BLASTER Assembly

1 Review

Part Number: WD21X20309

Drain Tube Kit

Part Number: WD24X10045

This kit includes the drain hose with black rubber end fittings and a clamp.

DRAIN TUBE Assembly

Part Number: WD24X10062

Conduit Adapter

Part Number: WD18X10051

This conduit adapter attaches to the central wash arm in your dishwasher to allow the arm to clean dishes thoroughly and properly. This genuine OEM adapter is made of high quality plastic and measures approximately 6 inches long by 4.5 inches wide.

Faucet Adapter

1 Review

Part Number: WD01X10383

This part is used to connect your dishwasher to your sink faucet.

Drain Hose

Part Number: WD24X10014

This drain hose is an OEM, manufacturer-approved replacement part for your dishwasher. The drain hose filters out the wastewater from the dishwasher. If there is a hole in it, water will leak out of your dishwasher. Shut off the water and power to the unit before beginning this repair. Accessing the drain hose involves unscrewing the dishwasher and pulling it out. Remove the clamp holding the hose in place to its connection under the sink, using a 5/16ths socket. Disconnect the fill line. Use a 1/4 inch nut driver to loosen the clamp at the other end of the drain hose. Keep a towel handy for any water still inside. Keep the clamps for use on your new drain hose. Reinstall all hoses and lines in reverse order.

HOSE CHAMBER

Part Number: WD24X10041

UNICOUPLE Assembly

Part Number: WD24X10066

This part is used to attach the drain & fill hose of your portable dishwasher to your faucet.